![]() ![]() The real file name and /dev/diskX with the actual device To the USB flash drive using the following command: sudo dd if=rescue.img of=/dev/disk1 dev/diskX command to unmount the flash drive. This means that you must reactivate and reconfigure the device afterwards. Statistics database, is completely rewritten. For additional instructions, continue with the Installing Kerio Control article.ĭuring the complete system recovery, all configuration data, including activation and the.Switch on the Kerio Control box for resetting the configuration.Plug the USB flash drive into a USB port of your Kerio Control box.The NTFS, ext2, ext3, or ext4 file systems. (VFAT) file system is created on the flash drive. Make sure that only one partition with the FAT16 or FAT32.See Formatting a USB flash drive with MBR. USB drives with floppy-type formatting cannot connect to Kerio Control NG 500, but can be reconfigured to work. Kerio Control NG 500 requires a flash drive formatted with a master boot record (MBR). There are two types of USB flash drives on the market. You perform the operation unplug the flash drive. An operationĭoes not repeat if you restart with the flash drive still in the USB port. This USB tool is designed for a single use. Including activation and the statistics database. Recovering to factory settings includes removal of all configuration data If you have any issues after using the tools, for example, if Kerio Control fails to work evenĪfter you perform a complete system recovery, please contact ![]() Kerio Control Box or Kerio Control Software Appliance. We recommend to use this method to update Kerio Control Box and Kerio Control Software Appliance A special operating system designed to run on a computer. You need a flash drive with the capacity of atįor restoring the default configuration, 256 MB suffice. These tools are designed to run from a USB flash drive. Situations in which it is not possible to connect to Kerio Control on a networkĪnd administer it through the Kerio Control Administration web interface. Kerio Technologies provides a set of tools for solutions for Restoring the Kerio Control Box NG series default configuration using a USB flash drive ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |